Cutting and mitres.
Cut to size in natural stone and porcelain, with mitred downstands and bonded step pieces finished in-house.
Cut clean. Mitred where it matters.
Four wetsaws and hand-held machinery in the workshop cover cutting across a large range of materials and thicknesses. When the edge needs a return — a downstand, a step riser, a clean internal or external corner — we mitre and bond the pieces so the grain and joint line up.
Mitred downstands run up to 150mm, including mitred and bonded step pieces. Work is finished by hand, in natural stone or porcelain, templated to your setting out.
For full bullnose and edge profiles, see bullnosing and profiling. For pool and step surrounds, see pool and step copings.
What's in scope.
Cutting and mitres, from one workshop.
- Four wetsaws in-house
- Hand-held machinery for awkward cuts
- Mitred downstands up to 150mm
- Mitred and bonded step pieces
- Natural stone & porcelain, varied thicknesses
- Templated in-house or on-site
Template. Cut. Mitre. Finish.
Each piece is set out against the real job, not only the drawing.
Template
Measured to your setting out, in-house or on-site.
Cut
Cut to size on the wetsaws or by hand.
Mitre
Downstands and returns cut, bonded and checked.
Finish
Edges finished by hand for a clean joint line.
Recent cutting and mitre work.
The spec behind recent jobs.
View all work →01Mitred downstands
02Mitred joint
Before you send the drawings.
How deep can mitred downstands go?
Mitred downstands up to 150mm, including mitred and bonded step pieces.
Do you only mitre, or cut flat pieces as well?
Both. Four wetsaws and hand-held machinery cover straight cuts and mitres across varied thicknesses.
Can cutting and mitres be done on-site?
Yes — on-site templating, cutting and finishing are available nationwide. See our on-site service.